E5CN/E5AN/E5EN Digital Temperature Controllers User’s Manual Basic Terminal block. E5CN. Basic Type. Analog input. Temperature input. safety standards, refer to your OMRON website. E5CN/E5AN/E5EN/E5GN Digital Temperature Controllers User’s Manual Basic Type (Cat. No. H). E5CN-H. Advanced Digital Temperature Controller (48 x 48 mm). E5CN-H between displaying the status of the Temperature Controller (auto/manual.

Author: Yosida Zubei
Country: South Africa
Language: English (Spanish)
Genre: Politics
Published (Last): 24 March 2007
Pages: 67
PDF File Size: 1.72 Mb
ePub File Size: 7.98 Mb
ISBN: 346-1-13048-298-7
Downloads: 57892
Price: Free* [*Free Regsitration Required]
Uploader: Arashisida

Function Setting range Unit Press the O key for at least three seconds to move from the operation Input type in-t Foreign particles Install the product in a location that is not subject to liquid or foreign particles entering the product. Upper and lower-limit alarm 2: Temperature Temperature Set value Troubleshooting Checking Problems If e5fn Temperature Controller is not operating normally, check the following points before requesting repairs.

Page Proportional band, Integral time, Derivative time adjustment level: Enter text from picture: For this example, set 2. Connect the power supply. Moreover, because OMRON is con- stantly striving to improve its high-quality products, the information contained in this manual is subject to change without notice. The set point limiter is used to prevent the control target from reaching abnormal tem- peratures.


Omron E5CN User Manual

The degree of protection is as shown below. The MV at stop takes priority when stopped and the manual MV takes pri- ority in manual mode. Page 63 Setting Output Specifications Section Operating Procedure The following example sets the following control and alarm assignments. When the power is turned ON, all of the display lights for approximately one second.

Page advanced function setting level Alarm 2 must be assigned. Page initial setting levelST stable range advance function setting level: Section Loop Break Alarm 3.


You can set alarm values, monitor the manipulated variable, and perform other operations in this level. Performance data given in this manual is provided as a guide for the user in determining suitability and does not constitute a warranty. Page of Go. Function Writing enabled OFF: When ALM1 is r-g.

Doing so may occasionally result in minor omronn due to electric shock. Page 74 Section Alarm Outputs Set value Alarm type Alarm output operation When alarm value X When alarm value X is positive is negative Lower-limit with standby sequence Absolute-value upper- limit Absolute-value lower-limit Absolute-value upper- limit with standby sequence Absolute-value lower-limit with standby sequence LBA alarm 1 type only Note PageAlarm 2 type: The MANU indicator will light during manual control.


Level Description ol-h MV upper limit: It may represent the result of OMRON’s test conditions, and the users must oron it to actual application requirements. The set point can be switched by operating the keys on the front panel or by using external input signals event inputs. Section Performing Manual Control Operating Procedure Use the following procedure to set the manipulated variable in manual mode.

No patent liability is assumed with respect to the use of the information contained herein. Don’t show me this message again.

Resistance thermometer input Except for models with a Resistance thermometer input Except for models with a setting range of Some parameters are not displayed depending on the protect level setting and the conditions of use.

At this time, install the driver using the instal- lation wizard. Refer to the following diagram for CT installation posi- tions. PageAlarm 3 hysteresis: To move to the advanced function setting level and calibration level, you must enter passwords.